Do you know the unloading steps for the powdered material carriers? There may be some owners who will say: This is not the case. Simple. Really simple? Often you only know about, some of the details will be ignored, Xiaobian today for the owners of friends to share the correct unloading operation steps of the powder material transporter, allowing you to use more secure, more durable vehicles. 1. Before discharge, check whether the unloading dish valve, external air source interface, exhaust valve, and the two inlets are closed and tightened. If they are not tightened, tighten them first to prevent air leakage. 2. Start the engine and shift the transmission to neutral. At the same time, depress the clutch pedal to completely separate the transmission from the engine. 3, open the power take-off solenoid valve switch, while slowly release the clutch pedal, so that the air compressor rotation. 4. Adjust the operating handle of the operating mechanism to adjust the air compressor speed to approximately 900 r/min and stabilize it. 5, when the pressure reaches 0.18MPa, first open the blowpipe, and then open the front and rear warehouse discharge disc valve, start unloading, after which the air compressor pointer will stabilize a certain value. 6, when the pressure dropped to 0.04Mpa, after the warehouse has been unloaded, close the blowpipe, after opening and closing the disc valve a few times, and then the rear compartment valve and the rear compartment intake valve is closed, that is, only the front warehouse discharge After that, the pressure will rise and stabilize to a certain value. 7. When the pressure of the barometer reaches 0 MPa, the unloading is completed, the air compressor is turned off (closing the power switch), and the unloading disc valve is closed. Chrome-Moly Steel Bar 4140 steel round bar,42CrMo4 steel round bar,SCM440 steel round bar,42CrMoS4 steel round bar,1.7225 steel round bar SHANDONG LE REN SPECIAL STEEL CO., LTD. , https://www.sdcolddrawnsteelbar.com