Tower Crane cabin is the control center of the crane and is attached to the slewing unit. In order to get to the tower crane cab, the operator must climb a series of ladders within the mast.
The movement of the tower crane is controlled from the operator`s cabin. Within the tower crane cabin, you`ll find the operator`s chair with joystick controller, electronic monitoring devices, and communication systems. Many cabins come with climate control to ensure a comfortable work environment. The Operator Cabin for Tower Crane is part of the slewing assembly. Tower Crane Cab,Tower Crane Cabin Chair,Tower Crane Operator Cabin, Operator Cabin for Tower Crane,Driver's Cabin for Tower Crane SHEN YANG BAOQUAN BUSINESS CO., LTD , https://www.sysuspendedplatform.com
　　
1, screw pump and motor from the emptying medium (to prevent the motor, toxic media wounding);
　　
2, remove the screw pump discharge body (1);
　　
3, remove the screw pump stator (6), if necessary, according to the axis of the pump shaft for auxiliary;
　　
4, remove the rotor (5) and the intermediate shaft (7);
　　
5, remove the drive shaft (44) and shaft seal;
　　
6, Remove the screw pump bearing (39) (41), positioning sleeve (40), should be taken out from the bearing housing;
　　
7, long-term without the screw pump, to make anti-rust treatment, the method is to use anti-rust grease smear non-painted metal surface, including the shaft surface, the filler housing cavity, and lubrication.
　　
Screw pump assembly, precautions:
　　
1, the assembly should be carefully cleaned screw parts, inspection, damaged parts should be replaced;
　　
2, the correct installation of bearings so that the shaft rotation flexible, no jamming phenomenon.
　　
3, shaft seal installation: stuffing box (18) installation, should make the packing gland (16) the position of the bolt in the shell installation window, easy to adjust the bolt wrench;
　　
4, mechanical seal installation should be careful, friction deputy face should be clean and coated with grease;
　　
5, the drive shaft twenty thousand joints to the assembly, the ring should be checked for damage, filled with grease in the cavity;
　　
6, when installing the stator, smearing the rotor with the lubricant, the surface of the stator cavity is conducive to the stator installation;
　　
7, the body pressed tight, the nut should be tightened uniform;
　　
8, installation and assembly, the coupling installation deviation: △ Y ≤ 0.2mm, △ α ≤ 30 '.
Screw pump removal and assembly should pay attention to what
Screw pump removal steps: